owl1
Зарегистрирован: 28.08.2002 Сообщения: 1
|
Добавлено: Ср Авг 28 2002 10:03 Заголовок сообщения: ошибка при загруке 3660 |
|
|
Есть cisco 3660 при включении она начинает загружаться и выдает ошибки, мне кажется, что у нее что то с железом, причем либо с памятью или с nvram, потому что она начинает грузить IOS и у нее не получается, вынимал из нее все модули, ошбика всегда одна и таже, причем так получилось, что память из нее ,в качестве дополнительной, ставили в другую циску этого же типа и с ней через сутки начиналось твориться непонятное. Вот что она пишет при загрузке
System Bootstrap, Version 12.0(6r)T, RELEASE SOFTWARE (fc1) Copyright (c) 1999 by cisco Systems, Inc. C3660 processor with 131072 Kbytes of main memory Main memory is configured to 64 bit mode with parity disabled
program load complete, entry point: 0x80008000, size: 0xaadac0 Self decompressing the image : *** TLB (Load/Fetch) Exception *** Access address = 0x10203a PC = 0x80020000, Cause = 0x80004008, Status Reg = 0x3041f003
*** CPU Out-of-range Interrupt *** Access address high = 0x0, low = 0x915c9c8 PC = 0xbfc10134, Cause = 0x4000, Status Reg = 0x3041f003
monitor: command "boot" aborted due to exception
System Bootstrap, Version 12.0(6r)T, RELEASE SOFTWARE (fc1) Copyright (c) 1999 by cisco Systems, Inc. C3660 processor with 131072 Kbytes of main memory Main memory is configured to 64 bit mode with parity disabled
PCMCIA Slot0: No Card Present
System Bootstrap, Version 12.0(6r)T, RELEASE SOFTWARE (fc1) Copyright (c) 1999 by cisco Systems, Inc. C3660 processor with 131072 Kbytes of main memory Main memory is configured to 64 bit mode with parity disabled
device does not contain a valid magic number boot: cannot open "slot1:" boot: cannot determine first file name on device "slot1:"
System Bootstrap, Version 12.0(6r)T, RELEASE SOFTWARE (fc1) Copyright (c) 1999 by cisco Systems, Inc. C3660 processor with 131072 Kbytes of main memory Main memory is configured to 64 bit mode with parity disabled
program load complete, entry point: 0x80008000, size: 0xaadac0 Self decompressing the image : *** Bus Error (Fetch) Exception *** Access address = 0x4 PC = 0x8915c9c8, Cause = 0x4018, Status Reg = 0x3041f003
*** CPU Out-of-range Interrupt *** Access address high = 0x0, low = 0x915c9c8 PC = 0xbfc10134, Cause = 0x4000, Status Reg = 0x3041f003
monitor: command "boot" aborted due to exception
System Bootstrap, Version 12.0(6r)T, RELEASE SOFTWARE (fc1) Copyright (c) 1999 by cisco Systems, Inc. C3660 processor with 131072 Kbytes of main memory Main memory is configured to 64 bit mode with parity disabled
rommon 1 > на этом все заканчивается, просто вываливается в командуную строку и все Заранее спасибо! |
|